|
ICE DAMS
An ice dam is a ridge of ice that forms at the
edge of a roof and prevents melting snow (water) from draining off the
roof. The water that backs up behind the dam can leak into a home and
cause damage to walls, ceilings, insulation, and other areas.
For
ice dams to form, there must be snow on the roof and higher portions of
the roof's outside surface must be above 32° F while lower surfaces are
below 32°F. For a portion of the roof to be below 32°F, outside
temperatures must also be below 32°F, and the temperatures must be
sustained over a significant period of time. Roofs with large surface
areas exposed to the sun and having small run-off areas are prone to ice
buildup. A classic example is a roof with several gables or dormers. Very
heavy snowfalls also can create problems: a foot or more of snow on a roof
combined with warm winter temperatures can warm the roof and cause snow
melt and ice on eaves.
The snow on a roof surface that's above 32°F
melts, and as the water flows down the roof, it reaches the portion of the
roof that is below 32°F and freezes, making a dam.
As
the dam grows, it is fed by the melting snow above it, but will limit
itself to the portions of the roof that are on average below 32°F. The
water above backs up behind the ice dam, remains a liquid, and finds
cracks and openings in the exterior roof covering and flows into the attic
space. From the attic it can flow into exterior walls or through the
ceiling insulation and stain the ceiling finish.
Warm areas on roofs can have several causes. Cold
wall-ceiling intersections at eaves where the insulation doesn't extend
far enough (Figure A). In split level buildings, unblocked stud bays to
the attic can cause warming problems where the stud bays continue past
ceiling joists to the attic (Figure B). In two-story buildings, a gap
below the knee wall in the second story is a common air leak area. Unless
the joist space is blocked below the knee wall, cold air enters the joist
space (Figure C).
While
adding insulation helps reduce ice dams, insulation above R-44 adds little
value. Roof vents are also, at best, a partial solution. Some people use
power ventilators such as attic fans or other motorized devices, but these
devices can depressurize the attic, drawing warm moist air out of the
house and into the attic. |